Hot tub tripping the electrics
When a hot tub knocks the power off, the outdoor supply is leaking or the heater is pulling too much current. Lighting Electrical in Peterborough measures that supply and tells you what failed.
Calls answered 24/7
- 10 years trading
Why does a hot tub trip the electrics?
A hot tub trips the electrics when current leaks from the outdoor supply to earth, or when the heater pulls more current than the breaker allows. That opens the tub breaker, or an RCD that also feeds other rooms.
- Water inside the outdoor isolatorAn isolator is the outdoor switch that cuts power to the tub. Rain through a cracked cover or a loose gland, the seal where the cable enters, bridges the terminals. Current leaks to earth and the RCD opens. An RCD is the safety switch that turns off when current leaves the circuit.
- A heater element leaking to earthThe heater warms the water and draws a heavy current. A split sheath lets water touch the live part of the element. Current leaks to earth, so the RCD opens after the tub has started to heat.
- A pump motor leaking to earthThe pump pushes water through the jets. Moisture in the motor lets current leak from the winding to the metal case and on to earth. The RCD opens as soon as the pump runs, while the heater is still off.
- A damaged cable to the isolatorThe fixed supply is the cable from the consumer unit to the outdoor isolator. A nick, a crushed seal or a wet joint lets the live conductor touch earth. The breaker or the RCD then opens with the tub already switched off.
- The tub sharing an RCD with the socketsAn RCBO is both a breaker and an RCD for one circuit. Without one, the tub sits on the same RCD as the sockets. A leak in the tub opens that RCD and those sockets switch off as well.
What can you check safely with the tub shut?
You can use the isolator handle, read the closed consumer unit and look at the outside of the supply. The tub panels, the isolator cover and the consumer unit cover stay screwed shut.
- The house with the tub switched offTurn the outdoor isolator handle to off and leave the cover shut. If the house power stays on, the leak is in the tub or the short flex after the isolator. If the power still drops, the fault is in the fixed cable or the consumer unit.
- Which switch on the consumer unit is downLook through the closed consumer unit door. A single breaker down means one circuit has opened. An RCD down, with the breakers still up, means current is leaking on a circuit that RCD protects.
- Water, cracks and the flex you can seeLook at the outside of the isolator, any plug and the visible flex. Standing water, a split cover or a chewed flex is enough to stop using the tub. Leave the gland and the inside of the switch untouched.
- Whether the trip waits for the heaterNote if the power fails the moment the pump starts, or only after the water starts to heat. A delayed trip points to the heater. An instant trip points to the pump or the supply cable.
When should you book for a tripping hot tub?
Book Now when the power drops again after the tub is switched off, or when the consumer unit or the outdoor isolator is hot, buzzing or smelling of burning. Keep the tub switched off while you wait.
- The power fails with the tub switched offThe isolator is off and the RCD or breaker still opens. The fault is in the fixed cable, the isolator or the consumer unit. Another reset heats the terminals, so that switch stays off.
- Heat, a buzz or a burning smellA warm consumer unit, a buzz or a burning smell means a joint is arcing. Arcing is a spark jumping across a loose terminal. Use the breaker handle to leave the circuit off, and keep your hands off the cover screws.
- Rain or floodwater around the supplyWater across the isolator or a flooded garden joint sends current to earth. With that circuit already off, stay clear of the wet plastic and the standing water. Book Now before anyone uses the tub again.
- Other rooms going off with the tubSockets or lights dying at the same moment mean the tub shares an RCD with those circuits. The leak can be small and still cut those rooms. Leave the RCD off when it will not hold with the tub isolated.
What happens on a visit for a tripping hot tub?
We test the outdoor supply with the tub circuit off and tell you whether the leak is in the fixed cable or in the tub. Repair of that cable, isolator or breaker waits until you accept it.
- When it trips and which switch openedWe ask whether the trip comes with the pump, the heater or the rain. We read the consumer unit beside you and look at the outdoor isolator. Every screw stays in until our tester shows the tub circuit is dead.
- Tests that separate the cable from the tubWe switch the tub circuit off and disconnect the tub at the isolator. An insulation test shows whether the fixed cable leaks to earth. A second test on the tub flex shows whether the leak is inside the tub. We name that result before any part comes off.
- Earthing, bonding and the tub loadWe name the failed part before we change it. We check earthing, the path that carries fault current, and bonding, the link between metalwork and that earth. We also check the supply can carry the tub load before any further price is written.
- The supply repair and the certificateYou accept the repair and we then fit the failed isolator, gland, cable or breaker. We test the circuit again and, where the circuit changed, write a minor works certificate through our NAPIT registration. A leak inside the tub stays with the tub disconnected so the house circuits can be on.
What does a tripping hot tub visit cost?
The hourly price for Electrical Fault Finding & Repair covers the tests on the hot tub supply, the cause we tell you, and the start of the repair after you accept it. A buried cable takes longer than a wet isolator on the wall. A part, a minor works certificate, a consumer unit change or emergency attendance changes the price.
From £75 an hour
Included when agreed
- Testing at the board and along the failed circuit until the cause is named
- A spoken diagnosis before any part is swapped
- Repair of the failed joint, accessory, cable or protective device once you accept the hourly work
- Making the circuit safe if it cannot be left live that day
- A minor works certificate when the repair needs one
Not included automatically
- A full house rewire or a new consumer unit as the first step
- Solar, battery, EV charger or forklift charger work
- Guesswork replacement of parts that have not failed
Ways to pay


- Pay by bank
- Bank transfer
- Time on a buried cable or a wet joint is longer than time on an isolator you can see on the wall.
- A failed breaker is replaced with Hager, Wylex, Contactum, BG Electrical or MK Electric only when the tests show it has failed.
- A consumer unit change, and Emergency electrician attendance, are each priced as their own job.
How booking works
Tell us about the job
Tap Book Now and describe the work in the chat. Photos help.
Get your price
You see your price in the chat. A set price is paid at checkout; any other job is quoted first.
Choose your visit
Give your address and when you are free, and the visit is arranged.
Why choose Lighting Electrical
We work with Hager, Wylex, Contactum, BG Electrical, MK Electric, Varilight, myenergi, Ohme, Hypervolt, Andersen, Aico, FireAngel and Mira.
- Reviews
- 61
- Rating
- 4.7
- Trading since
- 2016
“Ten years on Colchester housing stock and I have seen most of it: terraces where the lighting circuit has been extended once too often, boards fitted before RCDs were standard, new builds with sockets nowhere near the kitchen. I check the earthing, the bonding and whether the supply will carry another load before I price anything, because the age of a house settles nothing on its own.”
Valandi Kotorri, Lighting Electrical
Book NowCan the rest of the house stay on while you test the tub?
Yes. We switch off the hot tub circuit and leave every healthy circuit on. That circuit returns after the repair, and it stays off when the fixed wiring is still leaking.
Is the fault in my hot tub or in the garden cable?
We split the tub from the outdoor isolator and test the fixed cable alone. A leak that remains sits in the cable or the isolator. A sound cable beside a leak on the tub flex means the tub is the failed part.
Should I reset the switch again?
With the tub isolator off, reset the consumer unit once while it is cool, dry and quiet. A switch that opens again stays off, because another reset heats the cable. We then test that circuit with it dead.
Do you take the hot tub apart on the visit?
No. We repair the fixed supply, the isolator or the breaker after you accept the work. When the leak is inside the tub we leave the tub disconnected and the house circuits on.
What paperwork comes after the supply is repaired?
Where we alter the tub circuit, a minor works certificate records the tests and our NAPIT registration. If we change no part, you still get the readings and the named fault. A full Electrical Installation Condition Report covers the whole installation and is its own job.
Related problems
- Automatic gate not openingA gate that will not move has lost its supply, its safety beam or its motor control, so the outdoor circuit needs a test.
- Buzzing sound in the wallA buzz inside a wall is a loose joint, a dimmer or a damaged cable on that circuit.
- Circuit breaker keeps trippingThe breaker keeps tripping because a fault is still on the circuit, in an appliance, a cable, a joint or the protective device.
- Consumer unit tripping with nothing plugged inThe consumer unit trips with nothing plugged in because fixed wiring or the safety switch is sending current to earth.
- Downstairs circuit keeps trippingThe downstairs breaker or RCD opens because a socket, light, cable or appliance on that floor is leaking or overloaded.
- Driveway lights not workingDriveway lights go dark when the outdoor circuit, a sensor or a lantern fails, while rooms on another breaker stay lit.
Sources
- BS 7671: IET Wiring Regulations (18th Edition)
- IET, Guidance Note 7: Special Locations
- HSE: Electrical Safety at Work
- Electrical Safety First: Your questions answered
Updated 16 November 2026
