Contactum consumer units in Peterborough

Lighting Electrical fits new Contactum consumer units and repairs existing ones in Peterborough, so every circuit leaves the board on its own marked and tested breaker.

Calls answered 24/7

  • 10 years trading

Contactum consumer unit fitting and repair

A consumer unit is the box where every circuit in the building starts. We install Contactum units in homes and small premises, trace trips on existing Contactum boards and test the devices inside them.

  • Contactum Defender metal consumer unitsThe Contactum Defender range has a steel enclosure, which the wiring regulations expect inside a home. We fill it with RCBOs. An RCBO is a breaker with its own earth leakage protection, so a fault on one circuit drops only that circuit.
  • Surge and arc fault devices in a Contactum boardContactum makes a surge protection device, or SPD, that guards electronics against voltage spikes. It also makes arc fault detection devices, or AFDDs, that switch off a circuit when a loose joint starts to spark. We add them where the circuits need them.
  • Faults we fix on Contactum boardsA Contactum consumer unit shows no fault codes. We fix residual current devices, or RCDs, that trip and will not reset. We also fix breakers that drop when several heavy loads run together, and terminals or a main switch with heat marks.
  • What servicing a Contactum unit involvesServicing means retightening every terminal, timing each RCD and RCBO trip with a tester, checking the insulation on each circuit and renewing the circuit chart. Between visits, the test button on each RCD wants pressing every quarter.

Contactum’s website

How each service involves a Contactum board

EICR testing in Peterborough

EICR

from £150

An EICR, the electrical installation condition report, includes opening the Contactum unit. We look for heat marks on the busbar, the copper bar feeding the breakers, check every terminal and time each RCD and RCBO. A Contactum device that fails gets a code on the report.

Fuse board replacement

Contactum consumer unit replacement

from £450

We take out the old fuse box and mount a Contactum Defender unit in its place. Each circuit moves onto its own RCBO and is tested. Every circuit is named on the chart before the main switch goes back on.

House rewiring in Peterborough

House rewiring

from £2,400

Every new cable from a rewire ends at the consumer unit. A sound Contactum board with spare ways, the empty slots for breakers, can stay. An old or full board is replaced with a Contactum unit sized for the new circuits.

Electrical fault finding

Electrical fault finding

from £75 an hour

We begin at the Contactum board and read which RCD or RCBO has dropped. That circuit is isolated and tested section by section until the leaking appliance, joint or cable turns up.

Lighting installation

Lighting installation

from £65

New fittings on an existing lighting circuit only need that Contactum breaker off while we work. A brand new lighting circuit takes a spare way in the Contactum unit with its own labelled RCBO.

EV charger installation

EV charger installation

from £750

A chargepoint needs its own circuit and the right type of RCD. We fit a Contactum RCBO for it in a spare way. A board with no ways left gets a small Contactum enclosure beside it.

Socket and switch installation

Socket installation

from £85

Before a new socket joins a ring, we check the Contactum breaker feeding that ring and the earth leakage cover on it. A kitchen or garden socket gets RCD cover from the board.

Emergency electrician

Emergency electrician

from £90 an hour

When a Contactum main switch or RCD will not stay up out of hours, we switch off each breaker in turn to find the faulty circuit. That circuit stays off and the rest of the house comes back on.

Electrical testing and certificates

Electrical testing and certificates

from £95

PAT testing checks plug in appliances one by one and records a pass or fail. A kettle or heater that keeps tripping a Contactum RCD shows up on its insulation test.

Fire and smoke alarm installation

Smoke alarm installation

from £110

Mains smoke and heat alarms take their feed from the Contactum board. We connect them to a lighting circuit used every day or give them their own breaker, so a dead feed is noticed fast.

Appliance and heating connections

Appliance and heating connections

from £120

A cooker or electric heater must sit on a breaker that matches both its load and its cable. We read the rating on the Contactum device before connecting. The appliance stays off until breaker, cable and load match.

Solar and battery storage

Solar panel and battery storage installation

from £5,500

Solar generation joins the house through its own way in the consumer unit. We fit a Contactum breaker or a small Contactum board for the inverter with an isolator beside it. The main board is labelled to show it has a second supply.

Forklift charger installation

Forklift charger installation

from £700

Forklift chargers sit in warehouses, usually fed from a three phase distribution board. Where that board is Contactum, we add a breaker rated for the charger and an isolator at the bay that staff can reach.

Commercial lighting installation

Commercial Lighting Installation

from £65

Shop and office lighting runs from the distribution board in the premises. On a Contactum board we check each lighting breaker can carry the new fittings and write the area each way serves on the chart.

Starlink installation

Starlink installation

from £350

A Starlink dish runs from an ordinary socket. We mount the dish, seal its cable entry and set up the router. Any new socket for it goes on a circuit already protected in the Contactum board.

Light switch or dimmer replacement

Light switch or dimmer replacement

from £60

A switch or dimmer swap starts at the Contactum unit, where we turn off the lighting breaker and prove the circuit dead. Once the new control is fitted, the breaker goes back on and we try the lights.

Minor works certificate

Minor works certificate

from £95

The certificate names the device protecting the altered circuit. On a Contactum board we copy the make, type and rating of that RCBO or breaker onto the form with the test readings.

Extractor fan installation

Extractor fan installation

from £180

A fan is wired from the lighting circuit or a fused spur, a switched outlet with its own fuse. We isolate that circuit at the Contactum board, wire the fan, then test the circuit with the fan running.

Electric shower installation

Electric shower installation

from £220

An electric shower pulls a heavy current on its own circuit. We fit a Contactum RCBO rated for the shower, or a separate Contactum enclosure when the main board is full.

Emergency lighting test & certificate

Emergency lighting test & certificate

from £150

Emergency lights are tested by cutting their mains feed. Where that feed comes from a Contactum board, we switch off its breaker and watch each lamp run on battery. Then we restore the feed and certify the result.

Immersion heater repair

Immersion heater repair

from £70 an hour

A failed immersion element often leaks current and trips the Contactum RCD on that circuit. We test the element and thermostat at the cylinder, replace the failed part and check the device at the board stays on.

Battery storage installation

Battery storage installation

from £4,500

A home battery connects through its own protected way. We check the Contactum board, the earthing and the bonding can take it. Then we fit a dedicated breaker and label the board as having a second supply.

Fire alarm system installation

Fire alarm system installation

from £1,400

A fire alarm panel needs a mains feed nobody can switch off by accident. We give it a dedicated breaker in the Contactum board, marked in red on the chart and the device.

Cherry picker hire

Cherry picker hire

Cherry picker hire puts the electrician on a platform beside floodlights, signs and high bay fittings. A new high level lighting circuit reached that way is wired back to its own labelled breaker in the Contactum board.

Why has the whole house gone dark?

  • No power in the whole houseLook at the Contactum board first. If the main switch and every RCD are up and the street is dark too, call the network operator. If a Contactum device keeps dropping, we trace the circuit behind it.

Other brands we work on

How booking works

  1. Tell us about the job

    Tap Book Now and describe the work in the chat. Photos help.

  2. Get your price

    You see your price in the chat. A set price is paid at checkout; any other job is quoted first.

  3. Choose your visit

    Give your address and when you are free, and the visit is arranged.

Follow your job from booking to receipt

See when we're on our way, get your job report the moment we finish, and pay in seconds.

  • Track us on our way

    See us on the map with a live arrival time.

  • Your job report, same day

    See exactly what was done as soon as we finish.

  • Invoice and receipt in one place

    Pay online in seconds, and your receipt is always there when you need it.

Why choose Lighting Electrical

Photo of Valandi KotorriValandi KotorriElectrician
Reviews
61
Rating
4.7
Trading since
2016
“Ten years on Colchester housing stock and I have seen most of it: terraces where the lighting circuit has been extended once too often, boards fitted before RCDs were standard, new builds with sockets nowhere near the kitchen. I check the earthing, the bonding and whether the supply will carry another load before I price anything, because the age of a house settles nothing on its own.”

Valandi Kotorri, Lighting Electrical

Book Now

Contactum consumer unit questions

Still have a question?

What is a Contactum consumer unit?

Contactum is a British maker of consumer units, breakers and wiring accessories. Its Defender units have a steel enclosure and take RCBOs, surge devices and arc fault devices. We fit them and test every circuit before the power goes back on.

Can you add an RCBO to my Contactum board?

Yes, if the board has a spare way and the RCBO is a Contactum part made for that unit. Mixing makes of breaker in one board goes against the maker's instructions. We check the circuit and its earthing first, then fit and test the device.

Why does the RCD on my Contactum board keep tripping?

An RCD trips when current escapes to earth, often from damp in an outside light or a worn appliance element. We isolate the circuits on it one at a time and measure insulation until the readings point to the cause.

Can a Contactum consumer unit take an EV charger?

Often, when there is a spare way and the incoming supply can carry the extra load. We check the main fuse, the earthing and what the house already draws. A full board gets a small Contactum enclosure alongside for the charger circuit.

Is fitting a new Contactum consumer unit notifiable?

Yes. Changing a consumer unit is notifiable work, so we certify it and notify it through our NAPIT registration. You keep the certificate with a test result for every circuit.

Book or ask a question

Calls answered 24/7