MK Electric

MK Electric wiring accessories in Peterborough

Lighting Electrical fits and replaces MK Electric sockets, switches, dimmers and fused spurs in Peterborough, testing the earth and terminals at every point so each plate works when its circuit comes back on.

Calls answered 24/7

  • 10 years trading

MK Electric sockets, switches and spurs we fit

We work with MK Electric wiring accessories, the plates on your walls that you plug into or switch. MK sells several ranges, so we match the range already in the room or help you pick one before any plate comes off.

  • MK Logic Plus sockets and switchesLogic Plus is the white moulded MK range found in many homes. We fit its single and twin sockets, USB charging sockets and plate switches. USB versions sit deeper, so we check the back box, the box set in the wall behind the plate, has room.
  • MK metal plates and outdoor socketsFor a metal finish we fit MK ranges such as Albany Plus, Edge and Aspect. Outside we fit MK Masterseal Plus, a sealed socket that keeps out rain and dust, on a circuit with RCD protection. An RCD switches the circuit off when current leaks to earth.
  • Faults we fix on MK accessoriesMK sockets and switches show no fault codes. The faults we fix are heat marks at the pins, loose or burnt terminals, cracked plates, stiff rockers, a blown fuse in a spur, USB ports that stop charging and dimmers that hum with LED lamps.
  • What servicing MK accessories involvesThere are no parts inside to service. On a check we take plates off, tighten terminals, look for heat damage and test the earth at each point. Any plate that runs warm or has cracked is replaced like for like.

MK Electric’s website

How MK Electric sockets and switches fit into each job

EICR testing in Peterborough

EICR

from £150

An EICR is the electrical safety report on the fixed wiring. We take off a sample of MK sockets and switches, look for heat at the terminals, test the earth at each one and code any plate that is cracked or loose.

Fuse board replacement

Consumer unit replacement

from £450

The board change happens at the cupboard, and your MK plates stay where they are. Afterwards we plug a tester into MK sockets on each circuit to confirm polarity, earth and RCD trip times through the new consumer unit, the box of breakers.

House rewiring in Peterborough

House rewiring

from £2,400

Every point gets a new accessory at the end of a rewire. If you choose MK, we fit Logic Plus or a metal MK range on fresh back boxes, then test each socket and switch before its circuit is switched on.

Electrical fault finding

Electrical fault finding

from £75 an hour

Faults often show first at a wall plate, such as an MK socket that runs warm or a switch that crackles. We measure at that point and along the cable, and swap the MK accessory only if the readings put the fault inside it.

Lighting installation

Lighting installation

from £65

New fittings need a control on the wall. We fit MK plate switches, or an MK dimmer sized to the total LED load on that switch, so the lamps fade evenly.

EV charger installation

EV charger installation

from £750

The charge point is a different make on its own circuit, so MK parts do not feed it. Where you want an outdoor socket beside the charger for a jet washer, we fit an MK Masterseal Plus socket with RCD protection.

Socket and switch installation

MK Electric socket installation

from £85

This is where most MK work happens. We add or replace MK twin sockets, USB sockets and switches in white or metal finishes, check each circuit can carry the extra point and test every outlet once it is wired.

Emergency electrician

Emergency electrician

from £90 an hour

Out of hours, an MK socket or switch that is hot, smoking or sparking is isolated at the board and made safe. A replacement MK part follows once the circuit is safe to use.

Electrical testing and certificates

Electrical testing and certificates

from £95

PAT testing covers kettles, leads and tools that plug into MK sockets, not the sockets themselves. Each appliance gets a pass or fail, and the MK accessories are inspected under an EICR instead.

Fire and smoke alarm installation

Smoke alarm installation

from £110

Mains smoke and heat alarms are not MK products. Where an alarm circuit needs a local isolation point, we feed it through an MK fused spur, a switched outlet with its own fuse.

Appliance and heating connections

Appliance and heating connections

from £120

A cooker or oven is wired through an MK 45A double pole cooker switch, which cuts live and neutral together. We match that switch to the appliance rating and the cable size before making the connection.

Solar and battery storage

Solar panel and battery storage installation

from £5,500

Panels, inverters and batteries come from other makers, so MK has no part in the generating kit. We fit an MK fused spur or switch only where the inverter maker asks for a local mains isolator.

Forklift charger installation

Forklift charger installation

from £700

Forklift chargers run from an industrial isolator and plug, not an MK wall plate. We wire the charger circuit and isolator for the bay and leave nearby MK outlets untouched.

Commercial lighting installation

Commercial Lighting Installation

from £65

Shop and office switching gets daily use. We fit MK grid switches, where one plate carries several switch modules for separate banks of lights, and MK metal plates that stand up to knocks better than moulded ones.

Starlink installation

Starlink installation

from £350

The dish and its cable use no MK parts, and the router plugs into an ordinary socket. If the router sits far from any outlet, we add an MK socket on a nearby circuit so no extension lead is needed.

Light switch or dimmer replacement

Light switch or dimmer replacement

from £60

We remove the old control and fit an MK switch or dimmer on the existing back box. Dimmers are chosen for the lamps they run, because many LED lamps hum on a dimmer made for filament bulbs.

Minor works certificate

Minor works certificate

from £95

Adding an MK socket or spur to an existing circuit is a minor alteration. We test that circuit and record the new MK point, where it sits and its results on the minor works certificate.

Extractor fan installation

Extractor fan installation

from £180

Extractor fans are not MK products, but they need a way to be switched fully off for cleaning or repair. We fit an MK fan isolator, which breaks all three wires to the fan, outside the wet part of the room.

Electric shower installation

Electric shower installation

from £220

A shower needs a double pole switch out of reach of the water, either a ceiling pull cord or a wall switch outside the bathroom. We fit an MK 45A shower switch with a neon light, so you can see when power is on.

Emergency lighting test & certificate

Emergency lighting test & certificate

from £150

Emergency lamps and exit signs are not MK products. We test them by cutting their mains feed and timing each battery, while MK sockets on other circuits stay live.

Immersion heater repair

Immersion heater repair

from £70 an hour

The immersion runs through a 20A double pole switch near the cylinder. Where that switch is MK and its terminals show heat damage, we fit a new one while the element or thermostat is changed.

Battery storage installation

Battery storage installation

from £4,500

The battery and its inverter are another maker's equipment. Our work is the circuit, isolation and testing, and an MK switch goes in only if the battery maker calls for a mains isolator close by.

Fire alarm system installation

Fire alarm system installation

from £1,400

A fire alarm panel needs a mains feed that cannot be switched off by accident. We supply it through an MK unswitched fused connection unit, which has a fuse but no switch, and label it for the panel.

Cherry picker hire

Cherry picker hire

Cherry picker hire uses no MK parts. We deliver the machine and operate it for the booking, giving a steady platform for work on lights or signs high up.

Can a faulty MK socket black out the whole house?

  • No power in the whole houseYes, on some boards. An MK socket with a damp or scorched terminal can trip the RCD guarding it, and where one RCD serves several circuits the whole house goes dark. We reset the board, then test outward until the accessory behind the trip shows up.

Other brands we work on

How booking works

  1. Tell us about the job

    Tap Book Now and describe the work in the chat. Photos help.

  2. Get your price

    You see your price in the chat. A set price is paid at checkout; any other job is quoted first.

  3. Choose your visit

    Give your address and when you are free, and the visit is arranged.

Follow your job from booking to receipt

See when we're on our way, get your job report the moment we finish, and pay in seconds.

  • Track us on our way

    See us on the map with a live arrival time.

  • Your job report, same day

    See exactly what was done as soon as we finish.

  • Invoice and receipt in one place

    Pay online in seconds, and your receipt is always there when you need it.

Why choose Lighting Electrical

Photo of Valandi KotorriValandi KotorriElectrician
Reviews
61
Rating
4.7
Trading since
2016
“Ten years on Colchester housing stock and I have seen most of it: terraces where the lighting circuit has been extended once too often, boards fitted before RCDs were standard, new builds with sockets nowhere near the kitchen. I check the earthing, the bonding and whether the supply will carry another load before I price anything, because the age of a house settles nothing on its own.”

Valandi Kotorri, Lighting Electrical

Book Now

Questions about MK Electric sockets and switches

Still have a question?

Can you match new MK sockets to the ones I already have?

Yes, where that MK range is still made. Logic Plus white plates are widely stocked, and the metal ranges come in several finishes. If your range has ended, we show you the nearest current MK plate before fitting.

Can I change an MK socket for one with USB charging?

Usually, yes. MK USB sockets need a deeper back box, so we check the box and the earth before the old plate comes off. If the box is too shallow, we fit a deeper one first.

Why does my MK dimmer buzz with LED bulbs?

The dimmer is probably designed for filament bulbs, and LED lamps draw too little for it to control cleanly. An MK dimmer rated for LED loads, sized to the lamps on that switch, usually ends the hum.

Is a brown mark on an MK socket dangerous?

Yes, stop using it. A brown or melted patch around the pins means heat at a loose terminal or an overloaded plug. We change the plate, check the cable ends for damage, and test the circuit before it is used again.

Do you fit outdoor MK sockets?

Yes. We fit MK Masterseal Plus sockets, which seal against rain and dust when the lid is shut. Each one goes on a circuit with RCD protection and is tested once fitted.

Book or ask a question

Calls answered 24/7